Sicsi xxxx

device-thresholds /[email protected],0/pci1002,[email protected]/[email protected],0 10m device-thresholds /[email protected],0/pci1002,[email protected]/[email protected],0 10m device-thresholds /[email protected],0/pci1002,[email protected]/[email protected],0 10m device-thresholds /[email protected],0/pci1002,[email protected]/[email protected],0 10m This (theoretically) puts the 4 hard drives in standby mode after 10 minutes of inactivity.It is possible that your drives come with preconfigured values preventing them from being spun down before a factory-set delay or being spun at all (experiments with our WD Caviar Green drives are put in standby with a factory-set delay of ~8 minutes).

# nslookup 192.168.1.101 Server: 192.168.1.2 Address: 192.168.1.2#53 101.1.168.192.name = sanbox-if1.c7t0d0) just before the # zpool status san pool: san state: ONLINE scan: none requested config: NAME STATE READ WRITE CKSUM san ONLINE 0 0 0 raidz1-0 ONLINE 0 0 0 c7t0d0 ONLINE 0 0 0 c7t1d0 ONLINE 0 0 0 c7t2d0 ONLINE 0 0 0 c7t3d0 ONLINE 0 0 0 errors: No known data errors # # df -h Filesystem Size Used Avail Use% Mounted on (...) san 8.1T 45K 8.1T 1% /san The above just says: everything is in order, the pool is fully functional (not in a DEGRADED state).Not mandatory but at this point to do will do some (evils) tests. Too see, simply remove one of the disks from its bay without doing anything else :-).The first step is to identify the logical device name of the drives that will be used for our RAID-Z1 storage pool.If you have configured the power-management of the SAN box (see above paragraphs), you should have noticed that the format command returns something (e.g.For the record, the used switches here are Trend Net TEG-S80Dg, directly connected on a 120V plug no external PSU Before going on with the installation of Solaris, we have to do two operations: At date of writing, Jet Way published a newer BIOS revision (A03) for the motherboard, unfortunately the board has no built-in flash utilities accessible at machine startup so only solution is to build a bootable DOS USB Key using Qemu (unetbootin with a Free DOS failed has been tried but no joy): Ok this is not especially Funtoo related but the following notes can definitely saves you several hours.

You must have an account to comment. Please register or login here!